Electro-Voice REV Instruções de Operação descarregar pdf (Página 8)

Headphone Operation

1. With the transmitters and receivers setup and operating,

plug stereo headphones into the 1/4 inch jack on the front

panel.

2. The Selected Receiver LED will indicate receiver 1 is being

monitored. Press the Receiver Select button once to

change from Receiver 1 to 2.

3. Press the Receiver Select button once more and both indi-

cator LEDs will light. You can now listen to both receivers.

NOTE: if both receivers are set to the same channel, the

volume will double.

4. Pressing the Select button once more cycles back to

Receiver 1.

Antenna Connections

1. Install the two 1/2 wave antennas to the “antenna in” jacks

on the rear panel.

NOTE: The two 1/2 wave antennas included with the REV can

be remote mounted. For an additional 5dB gain use the LPA500

log periodic directional antenna.

2. The REV-DUAL is equipped with a left and right antenna

output jack. These jacks can be used to connect up to 3

REV-DUAL (6 receivers) to two antennas without any addi-

tional equipment. DO NOT remove “dummy” loads unless

connecting to another receiver.

3. Figure 3 shows the connection diagram for 3 REV-DUAL

units.

4. UP to 12 REV-DUAL units can be operated with just two

antennas with the optional APD4+ antenna distribution unit

(see Figure 4).

Figure 3

Antenna Chaining

Figure 4

Antenna Chain with APD4-B

-6-

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Sem comentários

Electro-Voice REV Instruções de Operação Página 8